Administrator Guide

Layer 3 Routing Commands 1854
console#show ipv6 ospf neighbor interface tunnel 1
IP Address..................................... 2.4.6.8
ifIndex........................................ 619
OSPF Admin Mode................................ Enable
OSPF Area ID................................... 0.0.0.0
Router Priority................................ 1
Retransmit Interval............................ 5
Hello Interval................................. 10
Dead Interval.................................. 40
LSA Ack Interval............................... 1
Iftransit Delay Interval....................... 1
Authentication Type............................ None
Metric Cost.................................... 1 (computed)
OSPF Mtu-ignore................................ Disable
OSPF cannot be initialized on this interface.
show ipv6 ospf range
Use the show ipv6 ospf range command in Privileged Exec mode to display
information about the area ranges for the specified area identifier.
Syntax
show ipv6 ospf range areaid
• areaid — Identifies the OSPF area whose ranges are being displayed.
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Configuration mode and all Configuration submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays information about the area ranges for area 1.
console#show ipv6 ospf range 1
Area ID IPv6 Prefix/Prefix Length Lsdb Type Advertisement
2CSNXXX_SWUM204.book Page 1854 Monday, January 25, 2016 1:25 PM