Administrator Guide

Layer 3 Routing Commands 1868
Example
console(config-router)#default-information originate
default-metric
Use the default-metric command in Router RIP Configuration mode to set a
default for the metric of distributed routes. Use the no form of the command
to return the metric to the default value.
Syntax
default-metric number-value
no default-metric
• number-value — Metric for the distributed routes. (Range: 1-15)
Default Configuration
Default metric is not configured by default.
Command Mode
Router RIP Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets a default of 12 for the metric of distributed
routes.
console(config-router)#default-metric 12
distance rip
Use the distance rip command in Router RIP Configuration mode to set the
route preference value of RIP in the router. Lower route preference values are
preferred when determining the best route. Use the no form of the command
to return the preference to the default value.
2CSNXXX_SWUM204.book Page 1868 Monday, January 25, 2016 1:25 PM