Administrator Guide

Layer 3 Routing Commands 1872
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
console(config-if-vlan2)#ip rip
console(config-if-vlan2)#no ip rip
ip rip authentication
Use the ip rip authentication command in Interface Configuration Mode to
set the RIP Version 2 Authentication Type and Key for the specified VLAN.
Use the no form of the command to return the authentication to the default
value.
Syntax
ip rip authentication {none | {simple key } | {encrypt key key-id }}
no ip rip authentication
• none—Do not use RIP authentication on the VLAN.
• simple—Use simple authentication on the VLAN.
•
key — Authentication key for the VLAN. (Range: 16 bytes or less)
• encrypt — Use MD5 encryption for the RIP interface.
•
key-id — Authentication key identifier for authentication type encrypt.
(Range: 0-255)
Default Configuration
This command has no default configuration.
2CSNXXX_SWUM204.book Page 1872 Monday, January 25, 2016 1:25 PM