Administrator Guide

Layer 3 Routing Commands 1882
Syntax
interface tunnel tunnel-id
no interface tunnel tunnel-id
• tunnel-id — Tunnel identifier. (Range: 0–7)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables the interface configuration mode for tunnel 1.
console(config)#interface tunnel 1
console(config-if-tunnel1)#
show interfaces tunnel
Use the show interfaces tunnel command in Privileged Exec mode to display
the parameters related to tunnel such as tunnel mode, tunnel source address
and tunnel destination address.
Syntax
show interfaces tunnel [ tunnel-id ]
• tunnel-id — Tunnel identifier. (Range: 0–7)
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Configuration mode and all Configuration submodes
2CSNXXX_SWUM204.book Page 1882 Monday, January 25, 2016 1:25 PM