Administrator Guide

Dell Networking CLI 187
max-metric router-lsa Configures OSPF to enable stub router
mode.
ROSPF
maximum-paths Sets the number of paths that OSPF can report
for a given destination.
ROSPF
network area Enables OSPFv2 on an interface and sets its area
ID if the IP address of an interface is covered by
this network command.
ROSPF
nsf Enables OSPF graceful restart. ROSPF
nsf helper Allow OSPF to act as a helpful neighbor for a
restarting router.
ROSPF
nsf helper strict-lsa-
checking
Set an OSPF helpful neighbor exit helper mode
whenever a topology change occurs.
ROSPF
nsf restart-interval Configures the length of the grace period on the
restarting router.
ROSPF
passive-interface Sets the interface or tunnel as passive. IC
passive-interface default Enables the global passive mode by default for all
interfaces.
ROSPF
passive-interface Sets the interface or tunnel as passive. ROSPF
redistribute (BGP) Configures OSPF protocol to allow redistribution
of routes from the specified source
protocol/routers.
ROSPF
router-id Sets a 4-digit dotted-decimal number uniquely
identifying the router OSPF ID.
ROSPF
router ospf Enters Router OSPF mode. GC
show ip ospf Displays information relevant to the OSPF
router.
PE
show ip ospf abr Displays the internal OSPF routing table entries
to Area Border Routers (ABR).
PE
show ip ospf area Displays information about the identified OSPF
area.
PE
show ip ospf asbr Displays the internal OSPF routing table entries
to Autonomous System Boundary Routes
(ASBR).
PE
Command Description Mode
a
2CSNXXX_SWUM204.book Page 187 Monday, January 25, 2016 1:25 PM