Administrator Guide

Layer 3 Routing Commands 1898
Syntax
ip vrrp
no ip vrrp
Default Configuration
VRRP is disabled by default.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables VRRP protocol on the router.
console(config)#ip vrrp
vrrp accept-mode
Use the vrrp accept-mode command in Interface (VLAN) Configuration
mode to enable the VRRP Master to accept ping packets sent to one of the
virtual router’s IP addresses from an external device. Use the no form of the
command to disable responding to ping packets.
Syntax
vrrp vrid accept-mode
no vrrp
vrid accept-mode
• vrid — Virtual router identification. (Range: 1-255)
Default Configuration
The default configuration is disabled.
Command Mode
Interface Configuration (VLAN) mode.
2CSNXXX_SWUM204.book Page 1898 Monday, January 25, 2016 1:25 PM