Administrator Guide

Layer 3 Routing Commands 1914
Pingable VRRP Commands
ip vrrp accept-mode
Use the ip vrrp accept-mode command in Interface (VLAN) Configuration
mode to enable the VRRP Master to accept ping packets sent to one of the
virtual router’s IP addresses. Use the no form of the command to disable
responding to ping packets.
Syntax
ip vrrp vrid accept-mode
no vrrp
vrid accept-mode
• vrid — Virtual router identification. (Range: 1-255)
Default Configuration
The default configuration is disabled.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
show ip vrrp interface
Use the show ip vrrp interface command in User Exec or Privileged Exec
mode to display the configured value for Accept Mode.
Syntax
show ip vrrp interface interface-id vrid
• interface-id — Any valid routing interface. See Interface Naming Conventions for
interface representation.
• vrid —The virtual router identifier. (Range: 1-255)
2CSNXXX_SWUM204.book Page 1914 Monday, January 25, 2016 1:25 PM