Administrator Guide

Switch Management Commands 1919
• max-megabytes — Set the maximum memory resource that the
application process(es) are allowed to consume. Expressed as megabytes
between 0 and 200. If 0 is specified, the application process(es) are not
limited. If this keyword is not specified, the default value is used. The
default is 0.
Default Configuration
By default, no applications are installed.
Command Mode
Global Configuration
User Guidelines
Application names may be up to 16 characters in length.
The name specified in the application-name parameter must match the
filename output of the show application command exactly. Application
names are case sensitive.
Command History
Introduced in version 6.3.0.1 firmware.
Example
console(config)#no application install support-assist
This action will terminate the support-assist agent and remove it permanently
from the switch. Are you sure you wish to continue (Y/N):
application start
Use the application start command to schedule an application for immediate
execution on the stack master.
Syntax
application start application-name
• application-name — The name of the application as shown in the show
application
command output.
2CSNXXX_SWUM204.book Page 1919 Monday, January 25, 2016 1:25 PM