Administrator Guide

Switch Management Commands 1924
Commands in this Section
This section explains the following commands:
boot auto-copy-sw
Use the boot auto-copy-sw command in Privileged Exec mode to enable or
disable Stack Firmware Synchronization.
Use the no form of the command to disable Stack Firmware Synchronization.
Syntax
boot auto-copy-sw
no boot auto-copy-sw
Default Configuration
Stack firmware synchronization is enabled by default.
Command Mode
Global Config
User Guidelines
The configuration on the master switch controls the stack as if it is a single
switch. No configuration steps need to be taken on the member switches to
synchronize the firmware.
boot auto-copy-sw boot host retrycount
boot auto-copy-sw allow-downgrade boot auto-copy-sw
boot host autoreboot show auto-copy-sw
boot host autosave show boot
boot host dhcp
–
2CSNXXX_SWUM204.book Page 1924 Monday, January 25, 2016 1:25 PM