Administrator Guide

Switch Management Commands 1988
no hiveagent
Default Configuration
By default, no HiveManager NG is configured by default.
Command Mode
Global Configuration
User Guidelines
This command enters HiveAgent Configuration mode. It allows the
administrator to configure HiveAgent information. The configured
information is stored in the running config. Use the write command to save
the information into the startup-config.
Command History
Introduced in version 6.3.0.1 firmware.
Example
In this example, the HiveAgent EULA has been accepted.
console(config)#hiveagent
console(conf-hiveagent)#
In this example, the HiveAgent EULA has been rejected.
console(config)#hiveagent
HiveAgent EULA has not been accepted.
The HiveAgent cannot be configured until the HiveAgent EULA is accepted.
console(config)#
server
Use the server command to configure a HiveAgent server (HiveManager NG)
and enter HiveAgent server configuration mode. Use the no form of the
command to remove a HiveAgent server.
2CSNXXX_SWUM204.book Page 1988 Monday, January 25, 2016 1:25 PM