Administrator Guide

Switch Management Commands 2013
The Dell Networking PoE solution also provides a global usage threshold
feature in order to limit the PoE switch from reaching an overload condition.
The operator can specify the limit as a percentage of the maximum power.
NOTE: PoE commands are only applicable to copper ports.
Commands in this Section
This section explains the following commands:
power inline
The power inline command enables/disables the ability of the port to deliver
power.
Syntax
power inline { auto | never }
no power inline
• auto — Enables device discovery and, if a device is found using the
method specified by the power inline detection setting,
supplies power to
the device.
•
never — Disables the device discovery protocol and stops supplying power
to the device.
Command Mode
Interface Configuration (Ethernet).
power inline power inline priority
power inline detection power inline reset
power inline four-pair forced power inline usage-threshold
power inline high-power clear power inline statistics
power inline management show power inline
power inline powered-device show power inline firmware-version
2CSNXXX_SWUM204.book Page 2013 Monday, January 25, 2016 1:25 PM