Administrator Guide

Switch Management Commands 2016
power inline high-power
Use this command to enable high power mode. Use the no form of this
command to disable high power mode.
Syntax
power inline high-power
no power inline high-power
Default Configuration
High power is enabled by default.
Command Mode
Interface Configuration.
User Guidelines
The system does not apply high power to the interface until an LLDP-MED
packet is received from the link partner requesting the application of high
power when configured in class based mode. Supplying power in excess of
34.2W requires Class D or better cabling.
High power must also be enabled if four pair power is enabled, otherwise, the
power delivered is undefined.
power inline management
Use the power inline management command in Global Configuration mode
to set the power management type. This command is used along with the
power inline priority command on page 2022. Use the no form of this
command to set the management mode to the default.
Syntax
power inline management [unit unit-id ]{dynamic | static | class}
no power inline management
• dynamic —Dynamic power management
•
static —Static power management
2CSNXXX_SWUM204.book Page 2016 Monday, January 25, 2016 1:25 PM