Administrator Guide

Dell Networking CLI 200
DHCP Client
Command Description Mode
a
boot system Specifies the system image that the switch loads
at startup.
PE
clear config Restores switch to default configuration. PE
copy Copies files from a source to a destination. PE
delete Deletes a file from a flash memory. PE
delete backup-image Deletes a file from a flash memory device. PE
delete backup-config Deletes the backup configuration file. PE
delete startup-config Deletes the startup configuration file. PE
dir Prints the contents of the flash file system. PE
erase Erases the startup configuration, the backup
configuration, or the backup image.
PE
filedescr Adds a description to a file. PE
rename Renames the file present in flash. PE
show backup-config Displays contents of a backup configuration
file.
PE
show bootvar Displays the active system image file that the
switch loads at startup.
UE
show running-config Displays the contents of the currently running
configuration file.
PE
show startup-config Displays the startup configuration file contents. PE
write Copies the running configuration image to the
startup configuration.
PE
a. For the meaning of each Mode abbreviation, see Mode Types on page 100.
Command Description Mode
a
release dhcp Forces the DHCPv4 client to release a
leased address.
PE
renew dhcp Forces the DHCP client to immediately renew
an IPv4 address lane.
PE
2CSNXXX_SWUM204.book Page 200 Monday, January 25, 2016 1:25 PM