Administrator Guide

Switch Management Commands 2032
• number —The event index. (Range: 1–65535)
•
log —An entry is made in the log table for each event.
•
trap —An SNMP trap is sent to one or more management stations.
•
community —If an SNMP trap is to be sent, it is sent to the SNMP
community specified by this octet string. (Range: 0-127 characters)
•
description —A comment describing this event. (Range 0-127 characters)
•
owner —Enter a name that specifies who configured this event. If
unspecified, the name is an empty string.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures an event with the trap index of 10.
console(config)#rmon event 10 log
rmon hcalarm
Use the rmon hcalarm to configure high capacity alarms.Use the no form of
the command to remove the alarm.
Syntax
rmon hcalarm alarmnumber variable interval {absolute | delta} rising-
threshold
value-64 [ rising-event-index ] falling-threshold value-64 [ falling-
event-index
] [startup {rising | falling | rising-falling}] [owner string ]
• alarmnumber —An alarm number that uniquely identifies the alarm entry.
(Range: 1-65536). Each entry defines a diagnostic sampler at a particular
interval for an object on the device.
2CSNXXX_SWUM204.book Page 2032 Monday, January 25, 2016 1:25 PM