Administrator Guide

Switch Management Commands 2047
Serviceability Commands
Dell Networking N1500/N2000/N3000/N4000 Series Switches
Debug commands cause the output of the enabled trace to display on a serial
port or telnet console. Note that the output resulting from enabling a debug
trace always displays on the serial port. The output resulting from enabling a
debug trace displays on all login sessions for which any debug trace has been
enabled. The configuration of a debug command remains in effect the whole
login session.
The output of a debug command is always submitted to the SYSLOG service
at a DEBUG severity level. As such, it can be forwarded to a SYSLOG server,
stored in the buffer log, or otherwise processed in accordance with the
configuration of the SYSLOG service. Configuration of console logging in the
SYSLOG service is not required in order to view the output of debug traces.
Debug commands are provided in the normal CLI tree. Debug settings are
not persistent and are not visible in the running configuration. To view the
current debug settings, use the show debug command.
The output of debug commands can be large and may adversely affect system
performance.
Enabling debug for all IP packets can cause a serious impact on the system
performance; therefore, it is limited by ACLs. This means debug can be
enabled for IP packets that conform to the configured ACL. This also limits
the feature availability to only when the QoS component is available. Debug
for VRRP and ARP are available on routing builds.
Commands in this Section
This section explains the following commands:
debug aaa
accounting
debug
igmpsnooping
debug ipv6 pimsm exception core-file
debug arp debug ip acl debug isdp exception dump
debug
authentication
interface
debug ip bgp debug lacp exception protocol
2CSNXXX_SWUM204.book Page 2047 Monday, January 25, 2016 1:25 PM