Administrator Guide

Switch Management Commands 2050
Example
console#debug arp
debug authentication interface
Use this command to enable Authentication Manager debug traces for the
interface.Use the no form of this command to set the debug trace to factory
default value.
Syntax
debug authentication {event | all} interface-id
no debug authentication {event | all} interface-id
• event —Traces Authentication Manager debug events.
•
all —Enables all Authentication Manager debugs.
•
interface-id —The interface to trace.
Default Configuration
Default value is disabled.
Command Modes
Privileged Exec mode
User Guidelines
Debug output should be enabled with caution. Switch behavior may be
adversely affected by the additional processing load incurred from enabling
debug.
Example
console# debug authentication event Gi1/0/1
console# debug authentication all Gi1/0/1
debug auto-voip
Use the debug auto-voip command to enable Auto VOIP debug messages. se
the optional parameters to trace H323, SCCP, or SIP packets respectively. Use
the “no” form of this command to disable Auto VOIP debug messages.
2CSNXXX_SWUM204.book Page 2050 Monday, January 25, 2016 1:25 PM