Administrator Guide

Switch Management Commands 2126
• port-security —Enable traps on port security violations.
•
port-security trap-rate —Configure the interval at which port security traps
are issued. Range 1-1000000 seconds. Default 30 seconds.
•
buffers —Enables sending of a trap on the internal message buffer count
exceeding the rising threshold.
•
cpu threshold —Enables sending of a trap on the CPU occupancy
exceeding the rising threshold.
•
multiple-users —Enable sending a trap when multiple logins are active.
•
link —Enable sending a trap when a link (interface) transitions to the
active state or the inactive state.
•
violation —Enable sending a trap when a port security MAC locking
violation occurs.
•
vrf-name —The name of an existing VRF instance
•
dvmrp —Enable dvmrp traps.
•
port-security —Enable traps on port security violations.
•
ospf —Enable OSPF event traps.
•
ospfv3 —Enable OSPFv3 event traps.
•
pim —Enable pim traps (pim-sm and pim-dm).
•
poe —Enable poe traps. This parameter is only available on PoE capable
switches.
•
snmp authentication —Enable snmp authentication traps.
•
spanning-tree —Enable traps on topology changes.
•
vrrp —Enable vrrp traps.
Default Configuration
SNMP authentication, link, multiple-user, spanning-tree, dot1q, and ACL
traps are enabled by default. Port-security traps are enabled by default.
Command Mode
Global Configuration mode.
2CSNXXX_SWUM204.book Page 2126 Monday, January 25, 2016 1:25 PM