Administrator Guide

Switch Management Commands 2133
• seconds —Number of seconds to wait for an acknowledgment before
resending informs. The default is 15 seconds. (Range: 1-300.)
•
retries —Maximum number of times to resend an inform request. The
default is 3 attempts. (Range: 0-255 characters.)
•
port —UDP port of the host to use. The default is 162. (Range: 1-65535.)
•
filtername — A string that is the name of the filter that defines the filter
for this host. If unspecified, does not filter anything (Range: 1-30
characters.)
Default Configuration
The default configuration is 3 retries, and 15 seconds timeout. This
command is disabled by default. No notifications are sent.
If you enter this command with no keywords, the default is to send all trap
types to the host. No informs are sent to this host. If no version keyword is
present, the default is Version 1.
Command Mode
Global Configuration mode
User Guidelines
If a DNS host name is entered instead of an IP address, the switch attempts
to resolve the host name immediately using DNS. Use the ip domain-lookup
command and the ip name-server command to enable resolution of DNS
host names.
Example
The following example enables SNMP traps for host 192.16.12.143.
console(config)# snmp-server host 192.16.12.143 Dell Networking traps v2
snmp-server location
Use the snmp-server location command in Global Configuration mode to set
the system location string. To remove the location string, use the no form of
this command.
2CSNXXX_SWUM204.book Page 2133 Monday, January 25, 2016 1:25 PM