Administrator Guide

Switch Management Commands 2134
Syntax
snmp-server location text
no snmp-server location
• text — Character string describing the system location. (Range: 1 to 255
characters.)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
The location string may contain embedded blanks if enclosed in quotes. Any
printable character is allowed in the string.
Example
The following example sets the device location as "New_York".
console(config)# snmp-server location New_York
snmp-server user
Use the snmp-server user command in Global Configuration mode to
configure a new SNMP Version 3 user. To delete a user, use the no form of this
command.
Syntax
snmp-server user username groupname [remote engineid-string ] [ { auth-
md5
password | auth-sha password | auth-md5-key md5-key | auth-sha-key
sha-key } [priv-des password | priv-des-key des-key | priv-3des password |
priv-3des-key
des-key | priv-aes128 password | priv-aes128-key aes-key ] ]
no snmp-server user
username
• username — Specifies the name of the user on the host that connects to
the agent. (Range: 1-32 characters.)
2CSNXXX_SWUM204.book Page 2134 Monday, January 25, 2016 1:25 PM