Administrator Guide

Switch Management Commands 2138
console(config)#snmp-server view "A beautiful view!" 1.1.2.1 included
snmp-server v3-host
Use the snmp-server v3-host command in Global Configuration mode to
specify the recipient of Simple Network Management Protocol Version 3
(SNMPv3) notifications. To remove the specified host, use the no form of
this command.
Syntax
snmp-server v3-host { ip-address | hostname } username {traps | informs}
[noauth | auth | priv] [timeout
seconds ] [retries retries ] [udpport port ]
[filter
filtername ]
no snmp-server v3-host
ip-address {traps | informs}
• ip-address — Specifies the IP address of the host (targeted recipient). Both
IPv4 and IPv6 addresses are allowed.
•
hostname — Specifies the name of the host. (Range: 1-158 characters.)
The command allows spaces in the host name when specified in double
quotes. For example, #snmp-server v3-host “host name”. Note that the
switch will not resolve host names that are not in conformance with RFC
1035.
•
username — Specifies user name used to generate the notification.
(Range: 1-30 characters.)
•
traps — Indicates that SNMP traps are sent to this host.
•
informs — Indicates that SNMPv2 informs are sent to this host.
•
noauth — Specifies sending of a packet without authentication.
•
auth — Specifies authentication of a packet without encrypting it
•
priv — Specifies authentication and encryption of a packet.
•
seconds — Number of seconds to wait for an acknowledgment before
resending informs. This is not allowed for hosts configured to send traps.
The default is 15 seconds. (Range: 1-300 seconds.)
•
retries — Maximum number of times to resend an inform request. This is
not allowed for hosts configured to send traps. The default is 3 attempts.
(Range: 0-255 retries.)
•
port — UDP port of the host to use. The default is 162. (Range: 1-65535.)
2CSNXXX_SWUM204.book Page 2138 Monday, January 25, 2016 1:25 PM