Administrator Guide

Switch Management Commands 2145
• phone —The complete phone number. Maximum of 23 printable
characters.
•
preferred-method —The preferred method of contact. May be either email
or phone.
Default Configuration
No contact person information is populated by default.
Command Mode
Support Asisst Configuration
User Guidelines
The email address must conform to RFC 5322 sections 3.2.3 and 3.4.1 and
RFC 5321. Additionally, the character set is further restricted to ASCII
characters.
This information is transmitted to Dell if the Dell SupportAssist service is
enabled.
This command can be executed multiple times. It overwrites the previous
information each time. The collected information is stored in the running-
config. The administrator must write the configuration in order to persist it
across reboots.
Command History
Introduced in version 6.3.0.1 firmware.
Example
The following example
console(config)# support-assist
console(conf-support-assist)#contact-person first john last doe email-
address primary [e-mail] phone [phone] preferred-method
email
enable
Use the enable command to enable a Dell SupportAssist server. Use the no
form of the command to disable a Dell SupportAssist server.
2CSNXXX_SWUM204.book Page 2145 Monday, January 25, 2016 1:25 PM