Administrator Guide

Switch Management Commands 2151
support-assist
Use the support-assist command to enable support-assist configuration mode
if the EULA has been accepted. Use the no form of the command to remove
the configured Dell SupportAssist information.
Syntax
support-assist
no support-assist
Default Configuration
By default, a server named “default” is configured. It may be disabled by the
administrator.
Command Mode
Global Configuration
User Guidelines
This command enters support-assist-conf mode. It allows the administrator
to configure Dell SupportAssist information. The configured information is
stored in the running config. Use the write command to save the information
into the startup-config.
Command History
Introduced in version 6.3.0.1 firmware.
Examples
Example 1
In this example, the SupportAssist EULA has been accepted.
console(config)#support-assist
console(conf-support-assist)#
Example 2
In this example, the SupportAssist EULA has been rejected.
console(config)#support-assist
2CSNXXX_SWUM204.book Page 2151 Monday, January 25, 2016 1:25 PM