Administrator Guide

Switch Management Commands 2184
[root@kevin ~]# ssh 192.168.12.84 -l dellradius
If you need to utilize this device or otherwise make changes to the
configuration, you may contact Kevin at x911.
Please, be advised this unit is under test by Kevin.
dellradius@192.168.12.84's password:
Press 'y' to continue (within 30 seconds) (y/n)
Welcome to the N3024 in the Bottom Chassis - 192.168.12.190. This unit is
located in A2 and is currently under test.
N3024-C1>
Telnet:
If you need to utilize this device or otherwise make changes to the
configuration, you may contact Kevin at x911.
Press 'y' to continue (within 30 seconds) (y/n) y
Please, be advised this unit is under test by Kevin.
User:root
Password:******
Welcome to the N3024 in the Bottom Chassis - 192.168.12.190. This unit is
located in A2 and is currently under test.
N3024-C1>
Example
console(config)# banner motd “There is a power shutdown at 23:00hrs today,
duration 1 hr 30 minutes.”
console(config)# banner motd acknowledge
When the MOTD banner is executed, the following displays:
IMPORTANT: There is a power shutdown at 23:00hrs today, duration 1 hr 30
minutes.
Press ‘y’ to continue
If ‘y’ is entered, the following displays:
console >
If ‘n’ is entered, the session will get disconnected, unless it is a serial
connection.
buffers
Use the buffers command to configure the rising and falling thresholds for
the issuance of the message buffer SNMP trap and notification via a
SYSLOG message.
2CSNXXX_SWUM204.book Page 2184 Monday, January 25, 2016 1:25 PM