Administrator Guide

Switch Management Commands 2195
Example
console(config-if-Gi1/0/1)#load-interval 150
locate
Use the locate command to locate a switch by LED blinking.
Syntax
locate [switch unit ] [time time ]
•switch unit —If multiple devices are stacked, you can choose which switch
to identify.
•
time time —LED blinking duration in seconds. Range 1-3600 seconds.
Default Configuration
Default value is 20 seconds.
Command Mode
Privileged EXEC
User Guidelines
When this command is executed on N1500, N2000 and N3000 switches, the
front panel power supply 1 LED blinks. On N4000 switches, the back panel
green "Locator" LED blinks.
The LED blinks until it times out. The user may select a new time value
while the LED is blinking. The last value selected takes effect immediately.
The locate command does not persist across reboots.
Example
console# locate switch 1 time 555
logout
Use this command to disconnect the serial connection to the remote unit on
the stack member.
2CSNXXX_SWUM204.book Page 2195 Monday, January 25, 2016 1:25 PM