Administrator Guide

Switch Management Commands 2197
member
Use the member command in Stack Global Configuration mode to
preconfigure a switch stack member. Execute this command on the
Management Switch. To remove a stack-member configuration from the
stack, use the no form of the command.
The no form of the command may not be used if the member is present in the stack.
Syntax
member unit switchindex
no member unit
• unit — The switch identifier of the switch to be added or removed from
the stack. (Range: 1–12)
•
switchindex — The index into the database of the supported switch types,
indicating the type of the switch being preconfigured. The switch index is
obtained from the
show supported switchtype command.
Default configuration
This command has no defaults.
Command Mode
Stack Global Configuration
User Guidelines
The switch index (SID) can be obtained by executing the show supported
switchtype
command in User Exec mode. When removing a unit from a
stack, use the no member command to remove the stack member
configuration after physically removing the unit.
Example
The following example displays how to add to stack switch number 2 with
index 1.
console(config)# stack
console(config-stack)# member 2 1
2CSNXXX_SWUM204.book Page 2197 Monday, January 25, 2016 1:25 PM