Administrator Guide

Switch Management Commands 2205
Command Modes
User EXEC mode, Privileged EXEC mode
User Guidelines
This command is available in privileged exec mode on the master unit serial
port and from the Unit prompt on member unit serial ports. The user need
not be currently connected over the serial port to connect to another unit.
The stack member being connected to must be up and running and
connected as part of the stack.
This command is an alias for the
exit command.
Example
Example 1:
To disconnect a remote session to the stack master established from a stack
member.
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>connect 1
Stack-Master#
Stack-Master#quit
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>
Example 2:
To disconnect a remote session to the stack master established from stack
member.
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>connect 1
Stack-Master#exit
Stack-Master>quit
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>
reload
Use the reload command in Privileged EXEC mode to reload stack members.
The reload command checks for stack port errors prior to reloading stack
members and after the check for unsaved configuration changes. If stack port
errors are found, a message is displayed.
Syntax
reload [ stack–member–number ]
2CSNXXX_SWUM204.book Page 2205 Monday, January 25, 2016 1:25 PM