Administrator Guide

Switch Management Commands 2233
If you supply a value for slot/port, the following additional information
appears as shown in the table below.
Example
console>show slot
Admin Power Configured Card
Slot Status State State Model ID Pluggable
----- ------ ------- ------- -------------------------------- ---------
1/0 Full Enable Enable Dell Networking N4032 No
1/1 Empty Disable Disable Yes
show supported cardtype
Use the show supported cardtype command in User EXEC mode to display
information about all card types supported in the system. If a card index is
entered, then the command displays information about specific card types
supported in the system. Card index values are specific to each family of
products. Use the generic form (without specifying an index) to display all the
card types for a product family.
Syntax
show supported cardtype [ cardindex ]
Pluggable Cards are pluggable or non-pluggable in
the slot.
Parameter Description
Inserted Card Model Identifier The model identifier of the card inserted
in the slot. Model identifier is a 32-
character field used to identify a card.
This field is displayed only if the slot is
full.
Inserted Card Description The card description. This field is
displayed only if the slot is full.
Configured Card Description The description of the card preconfigured
in the slot.
Parameter Description
2CSNXXX_SWUM204.book Page 2233 Monday, January 25, 2016 1:25 PM