Administrator Guide

Switch Management Commands 2237
Model Identifier............... Dell Networking N4032
Slot........................... 1
Card Index (CID)............... 5
Model Identifier............... Dell QSFP Card
Slot........................... 1
Card Index (CID)............... 6
Model Identifier............... Dell SFP+ Card
Slot........................... 1
Card Index (CID)............... 7
Model Identifier............... Dell 10GBase-T Card
show switch
Use the show switch command in User EXEC mode to display information
about units in the stack.
The show switch command shows the configuration and status of the
stacking units, including the active and standby stack management units, the
preconfigured model identifier, the plugged in model identifier, the switch
status and the current code version. Both the preconfigured switch type (as
set by the member command in stack mode) and the actual connected switch
type, if any, are shown.
The show switch
unitid command also shows details of the switch
configuration including the SFS last attempt status for the specified unit. If
there is a stack firmware synchronization (SFS) operation in progress, the
switch status will show as Updating Code.
The show switch command may show an SDM Mismatch value in the Switch
Status field. This value indicates that the unit joined the stack, but is running
a different SDM template than the management unit. This status should be
temporary; the stack unit should automatically reload using the template
running on the stack manager.
Use the show supported switchtype command to display switch SIDs.
Use the show stack-ports command to display details regarding stacking links.
Use the show switch stack-ports stack-path command to display the active
path from one stacking unit to another.
Use the show slot command to display details regarding slot configuration.
2CSNXXX_SWUM204.book Page 2237 Monday, January 25, 2016 1:25 PM