Administrator Guide

Switch Management Commands 2242
Example-Stacking Links Path
This command tracks the path a packet may take when traversing stacking
links. The command shows active paths only, not those that may be taken
after a stack failover or stack reconvergence.
console#show switch stack-ports stack-path 3 1
Packet-path from unit 3 to unit 1:
1 unit-3 port gi3/0/49 to unit-2
2 unit-2 port gi2/0/49 to unit-1
Example – Switch Firmware Stack Status
The following example displays the Switch Firmware stack status information
for the switch.
console#show switch
Management Standby Preconfig Plugged-in Switch Code
SW Switch Status Model ID Model ID Status Version
--- ---------- --------- ------------- ------------- ------------- ---------
1 Mgmt Sw N3024 N3024 OK 6.0.0.0
2 Stack Mbr N3024 N3024 Updating Code 6.0.0.0
console#show switch 1
Switch............................ 1
Management Status................. Management Switch
Switch Type....................... 0x63400004
Preconfigured Model Identifier.... N3048P
Plugged-in Model Identifier....... N3048P
Switch Status..................... OK
Switch Description................ Dell Networking N3048P
Detected Code Version............. 6.0.0.0
Detected Code in Flash............ 6.0.0.0
SFS Last Attempt Status........... None
Serial Number..................... 13820M0230LF
Up Time........................... 0 days 3 hrs 1 mins 13 secs
Example – SDM Templates
This example shows the SDM Mismatch value in the Switch Status field.
console(config)#show switch
Management Standby Preconfig Plugged-in Switch Code
SW Status Status Model ID Model ID Status Version
2CSNXXX_SWUM204.book Page 2242 Monday, January 25, 2016 1:25 PM