Administrator Guide

Switch Management Commands 2253
stack
Use the stack command in Global Configuration mode to set the mode to
Stack Global Config.
Syntax
stack
Default Configuration
This command has no default mode.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines. If not stack configuration appears in
the saved config, it is built at runtime and appears in the running config. The
operator can save the stack configuration. Stack members that do not match
the saved config after a reboot will show a config mismatch and do not join
the stack.
Example
The following example sets the mode to Stack Global Config.
console(config)#stack
console(config-stack)#
stack-port
Use the stack-port command in Stack Configuration mode to configure ports
as either Stacking ports or as Ethernet ports. This command is used to
configure Ethernet ports to operate as either stacking or Ethernet ports, or to
configure stacking modules to operate as Ethernet ports.
NOTE: This command is only valid on N1500 and N4000 switches. It issues an error
response if used on the N2000 or N3000 switches.
2CSNXXX_SWUM204.book Page 2253 Monday, January 25, 2016 1:25 PM