Administrator Guide

Switch Management Commands 2284
Default Configuration
The default privilege level is 15.
Command Mode
User Exec and Privileged Exec modes
User Guidelines
If there is no authentication method defined for enable, then a level 1 user is
not allowed to execute this command.
Example
The following example shows how to enter privileged mode.
console>enable
console#
end
Use the end command to get the CLI user control back to the privileged
execution mode or user execution mode.
Syntax
end
Default Configuration
This command has no default configuration.
Command Mode
All command modes
User Guidelines
No specific guidelines.
Example
console(config)#end
console#end
console>
2CSNXXX_SWUM204.book Page 2284 Monday, January 25, 2016 1:25 PM