Administrator Guide

Layer 2 Switching Commands 337
Syntax
show dhcp l2relay all
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Configuration mode and all Configuration submodes
User Guidelines
There are no user guidelines for this command.
Example
console #show dhcp l2relay all
DHCP L2 Relay is Enabled.
Interface L2RelayMode TrustMode
---------- ----------- --------------
Gi1/0/2 Enabled untrusted
Gi1/0/4 Disabled trusted
VLAN Id L2 Relay CircuitId RemoteId
--------- ---------- ----------- ------------
3 Disabled Enabled --NULL--
5 Enabled Enabled --NULL--
6 Enabled Enabled --dell--
7 Enabled Disabled --NULL--
8 Enabled Disabled --NULL--
9 Enabled Disabled --NULL--
10 Enabled Disabled --NULL--
show dhcp l2relay interface
Use the show dhcp l2relay interface command to display DHCP L2 Relay
configuration specific to interfaces.
Syntax
show dhcp l2relay interface {all | interface-id }
• all — Show all interfaces.
• interface-id — An Ethernet interface.
2CSNXXX_SWUM204.book Page 337 Monday, January 25, 2016 1:25 PM