Administrator Guide

Layer 2 Switching Commands 394
User Guidelines
When both speed and duplex are configured to auto, auto negotiation is
enabled for the port. To disable auto-negotiation on a port, it is necessary to
enter both the speed and duplex commands without using the auto
parameter. 10G/40G fiber ports do not support auto-negotiation and
therefore require the operator to enter the duplex full command and the
speed command with the desired operating bandwidth. Auto-negotiation is
required on 1G/10G/40G copper ports and 1G fiber ports.
The duplex command is only available on the Dell Networking N1500 Series
switches. Other switch models support full duplex operation only.
Example
The following example configures the duplex operation of Tengigabit
Ethernet port Te 1/0/5 to force full duplex operation, disable auto-
negotiation, and set the speed to 1000M.
console(config)# interface te1/0/5
console(config-if-Te1/0/5)# duplex full
console(config-if-Te1/0/5)# speed 1000
flowcontrol
Use the flowcontrol command in Global Configuration mode to configure
the flow control. To disable flow control, use the no form of this command.
Syntax
flowcontrol receive {on | off}
no flowcontrol receive
Default Configuration
Flow Control is enabled by default.
Command Mode
Global Configuration and Interface Configuration modes
2CSNXXX_SWUM204.book Page 394 Monday, January 25, 2016 1:25 PM