Administrator Guide

Layer 2 Switching Commands 406
10000f 1000f 1000h 100f 100h 10f 10h
------ ----- ----- ----- ----- ----- ----
Admin Local link Advertisement no yes no yes no yes no
Oper Local link Advertisement no yes no yes no yes no
Oper Peer Advertisement no yes no yes no yes no
Priority Resolution - - - yes - - -
show interfaces configuration
Use the show interfaces configuration command in User Exec mode to
display the configuration for all configured interfaces.
Syntax
show interfaces configuration [{gigabitethernet unit/slot/port| port-channel
port-channel-number | tengigabitethernet unit/slot/port |
fortygigabitethernet unit/slot/port}]
Default Configuration
This command has no default configuration.
Command Mode
User Exec mode, Configuration mode and all Configuration submodes
User Guidelines
The displayed port configuration information includes the following:
Field Description
Port The port number.
Description The port designated IEEE shorthand identifier. For example
1000Base-T refers to 1000 Mbps baseband signaling including both
Tx and Rx transmissions.
Duplex Displays the port Duplex status.
Speed Refers to the port speed.
Neg Describes the Auto-negotiation status.
MTU The Maximum Transmission Unit.
2CSNXXX_SWUM204.book Page 406 Monday, January 25, 2016 1:25 PM