Administrator Guide

Layer 2 Switching Commands 416
Example
The following example displays the status for all configured interfaces.
console(config-if-Po1)#show interfaces status
Port Description Duplex Speed Neg Link Flow M VLAN
State Ctrl
--------- --------------- ------ ------- ---- ------ ----- - ---------------
Gi1/0/1 N/A Unknown Auto Down Off A 1
Gi1/0/2 N/A Unknown Auto Down Off T (11),1,3,5,7,9
15,19,25-4093
Gi1/0/3 N/A Unknown Auto Down Off A 1
Gi1/0/4 N/A Unknown Auto Down Off G (1),2,4,6,8,10
14,16,20,22,24
Gi1/0/5 N/A Unknown Auto Down Off A 1
Gi1/0/6 N/A Unknown Auto Down Off A 1
Gi1/0/7 N/A Unknown Auto Down Off A 1
Gi1/0/8 N/A Unknown Auto Down Off A 1
Gi1/0/9 N/A Unknown Auto Down Off A 1
Oob Type Link
State
--- ------------------------------ -----
oob Out-Of-Band Up
Port Description Link M VLAN
Channel State
------- ------------------------------ ------- - -------------------
Po1 Down H (4),5
show interfaces transceiver
Use the show interfaces transceiver command to display the optic static
parameters as well as the Dell qualification.
Syntax
show interfaces transceiver [properties]
• properties—Displays the static parameters for the optics.
Default Configuration
This command has no default configuration.
2CSNXXX_SWUM204.book Page 416 Monday, January 25, 2016 1:25 PM