Administrator Guide

Layer 2 Switching Commands 434
• vlan-id —VLAN ID representing a service instance that is monitored by
this maintenance association. The range is 1-4093.
• secs—Time interval between successive transmissions. The range is 1, 10,
60, and 600 seconds. The default is 1 second.
Default Configuration
CCMs are not sent by default.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
console(config)#ethernet cfm cc level 1 vlan 15 interval 10
ethernet cfm mep level
Use the ethernet cfm mep level command in Interface Configuration mode
to create a Maintenance End Point (MEP) on an interface at the specified
level and direction. MEPs are configured per Maintenance Association per
Maintenance Domain. Use the no form of the command to delete a MEP.
Syntax
ethernet cfm mep level 0-7 direction up|down mpid 1-8191 vlan vlan-id
• level —Maintenance association level
•
direction — Up indicates the MEP is facing towards Bridge Relay Entity. Down
indicates the MEP is facing towards the LAN.
• mpid — Maintenance entity identifier
• vlan-id — VLAN on which the MEP operates. The range is 1-4093.
Default Configuration
No MEPs are preconfigured.
2CSNXXX_SWUM204.book Page 434 Monday, January 25, 2016 1:25 PM