Administrator Guide

Layer 2 Switching Commands 436
Example
The following example enables a maintenance endpoint at level 1 with mpid
1010 on vlan 10.
console(config-if-Gi1/0/3)#ethernet cfm mep enable level 1 vlan 10 mpid 1010
ethernet cfm mep active
Use the ethernet cfm mep active command in Interface Configuration mode
to activate a MEP at the specified level and direction. Use the no form of the
command to deactivate the MEP.
Syntax
ethernet cfm mep active level 0-7 vlan vlan-id mpid 1-8191
• level —Maintenance association level
•
mpid — Maintenance entity identifier
• vlan — VLAN on which the MEP operates. The range is 1-4093.
Default Configuration
No MEPs are preconfigured.
Command Mode
Interface Configuration
User Guidelines
This command has no user guidelines.
ethernet cfm mep archive-hold-time
Use the ethernet cfm mep archive-hold-time command in Interface
Configuration mode to maintain internal information on a missing MEP. Use
the no form of the command to return the interval to the default value.
Syntax
ethernet cfm mep archive-hold-time hold-time
2CSNXXX_SWUM204.book Page 436 Monday, January 25, 2016 1:25 PM