Administrator Guide

Layer 2 Switching Commands 455
Tx Low Power Idle Event Count.... 0
Tx Low Power Idle Duration (uSec) 0
Tw_sys_tx (usec)..................17
Tw_sys_tx Echo(usec)..............17
Tw_sys_rx (usec)..................17
Tw_sys_tx Echo(usec)..............17
Fallback Tw_sys (usec)............17
Remote Tw_sys_tx (usec)...........21
Remote Tw_sys_tx Echo(usec).......21
Remote Tw_sys_rx (usec)...........21
Remote Tw_sys_tx Echo(usec).......21
Remote fallback Tw_sys (usec).....21
Tx DLL enabled....................Yes
Tx DLL ready......................Yes
Rx DLL enabled....................Yes
Rx DLL ready......................Yes
Cumulative Energy Saving (W * H)..2.37
Time Since Counters Last Cleared..1 day 20 hr 47 min 34 sec
show green-mode
Use the show green-mode command to display the green-mode configuration
for the whole system. The status is shown only for the modes supported on
the corresponding hardware platform whether enabled or disabled.
Syntax
show green-mode
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec
User Guidelines
This command output provides the following information.
Term Description
Energy Detect
2CSNXXX_SWUM204.book Page 455 Monday, January 25, 2016 1:25 PM