Administrator Guide

Layer 2 Switching Commands 496
Example
console(config)#show errdisable recovery
Reason Auto-recovery Status
------------------ ---------------------
ARP Inspection Disabled
BPDU Guard Disabled
Broadcast Storm Disabled
BPDU Storm Disabled
DHCP Rate Limit Disabled
Loop Protect Disabled
Multicast Storm Disabled
SFP Mismatch Disabled
SFP Plus Mismatch Disabled
UDLD Disabled
Unicast Storm Disabled
Port MAC Locking Disabled
Denial of Service Disabled
Interval for auto-recovery of error disabled interfaces: 300 seconds
show interfaces status err-disabled
Use the show interfaces status err-disabled command to display the
interfaces that are error disabled by the system.
Syntax
show interfaces status err-disabled
Default Configuration
No recovery causes are enabled by default.
Command Mode
Privileged EXEC mode
User Guidelines
Error disabled interfaces indicate that a problem that must be resolved by the
administrator. This could be a configuration problem or a physical problem
and does not necessarily indicate a problem with the switch.
2CSNXXX_SWUM204.book Page 496 Monday, January 25, 2016 1:25 PM