Administrator Guide

Layer 2 Switching Commands 513
no ipv6 address { prefix/prefix-length [eui64] | autoconfig | dhcp}
• prefix/prefix-length —An IPv6 prefix in global format address format.
•
eui64 —Formulate the prefix in EUI-64 format.
•
autoconfig —Perform IPv6 auto-configuration.
•
dhcp —Obtain the prefix via DHCP.
Default Configuration
No address is assigned to the out-of-band interface by default.
Command Mode
Interface (out-of-band) Configuration mode
User Guidelines
When DHCPv6 is enabled on the Out-of-Band interface, the system
automatically deletes all manually configured IPv6 addresses on the interface.
DHCPv6 can be enabled on the Out-of-Band interface only when IPv6 auto
configuration or DHCPv6 is not enabled on any of the in-band management
interfaces.
IPv6 auto configuration mode can be enabled in the Out-of-Band interface
only when IPv6 auto configuration or DHCPv6 is not enabled on any of the
in-band management interfaces.
The optional eui64 parameter indicates that the IPv6 address is configured to
use the EUI-64 interface ID in the low order 64 bits of the address. In this
parameter is specified, the
prefix-length must be 64.
ipv6 address dhcp
Use the ipv6 address dhcp command in Interface (VLAN) Configuration
mode to enable the DHCPv6 client on an IPv6 interface.
Syntax
ipv6 address dhcp
no ipv6 address dhcp
2CSNXXX_SWUM204.book Page 513 Monday, January 25, 2016 1:25 PM