Administrator Guide

Layer 2 Switching Commands 515
Command Mode
Interface Configuration mode (VLAN, tunnel, loopback)
User Guidelines
There are no user guidelines for this command.
Example
console(config)#no ipv6 enable
ipv6 enable (OOB Configuration)
Use the ipv6 enable command in Interface (out-of-band) Configuration
mode to enable IPv6 operation on the out-of-band interface. Prefixes
configured by the ipv6 address command are not configured until the
interface is enabled.
Syntax
ipv6 enable
no ipv6 enable
Default Configuration
By default, IPv6 is not enabled on the out-of-band port.
Command Mode
Interface (out-of-band) Configuration mode
User Guidelines
This command is not necessary if an IPv6 address has been assigned to the
interface.
2CSNXXX_SWUM204.book Page 515 Monday, January 25, 2016 1:25 PM