Administrator Guide

Layer 2 Switching Commands 516
ipv6 gateway (OOB Configuration)
Use the ipv6 gateway command in Interface (out-of-band) Configuration
mode to configure the address of the IPv6 gateway. The gateway is used as a
default route for packets addressed to network devices not present on the
local subnet. Use the no form of the command to remove the gateway
configuration.
Syntax
ipv6 gateway ipv6-address
no ipv6 gateway
• ipv6-address —An IPv6 address (not a prefix).
Default Configuration
By default, no IPv6 gateway is configured.
Command Mode
Interface (out-of-band) Configuration mode
User Guidelines
There are no user guidelines for this command.
show hosts
Use the show hosts command in User Exec mode to display the default
domain name, a list of name server hosts, and the static and cached list of
host names and addresses.
Syntax
shows hosts [ hostname ].
• hostname —(Range: 1–255 characters). The command allows spaces in the
host name when specified in double quotes. For example,
console(config)#show hosts "host name"
2CSNXXX_SWUM204.book Page 516 Monday, January 25, 2016 1:25 PM