Administrator Guide

Layer 2 Switching Commands 518
Default Configuration
This command has no default configuration.
Command Mode
User Exec, Privileged Exec mode, Configuration mode and all Configuration
submodes
User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
The VRF parameter is only available on the N3000/N4000 series switches.
The command provides the following information.
Example
console#show ip address-conflict
Address Conflict Detection Status...Conflict Detected
Last Conflicting IP Address.........10.131.12.56
Last Conflicting MAC Address........00:01:02:04:5A:BC
Time Since Conflict Detected........5 days 2 hrs 6 mins 46 secs
console#show ip address-conflict
Address Conflict Detection Status..No Conflict Detected
Term Description
Address Conflict
Detection Status
Whether the switch has detected an address conflict on any IP
address. Set to Conflict Detected if detected, No Conflict
Detected otherwise.
Last Conflicting IP
Address
The IP address that was last detected as conflicting on any
interface.
Last Conflicting
MAC Address
The MAC Address of the conflicting host that was last detected
on any interface.
Time Since Conflict
Detected
The time in days, hours, minutes, and seconds since the last
address conflict was detected.
2CSNXXX_SWUM204.book Page 518 Monday, January 25, 2016 1:25 PM