Administrator Guide

Layer 2 Switching Commands 550
• interval — Amount of time that the switch waits before sending another
general query. (Range: 1–1800 seconds)
Default Configuration
The default query interval is 60 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command
Example
console(config)#ipv6 mld snooping querier 120
ipv6 mld snooping querier timer expiry
Use the ipv6 mld snooping querier timer expiry command to set the MLD
Querier timer expiration period. It is the time period that the switch remains
in Non-Querier mode once it has discovered that there is another Multicast
Querier in the network. Use the no form of this command to reset the timer
expiration period to the default.
Syntax
ipv6 mld snooping querier timer expiry timer
ipv6 mld snooping querier timer expiry
• timer — The time that the switch remains in Non-Querier mode after it
has discovered that there is a multicast querier in the network. (Range:
60–300 seconds)
Default Configuration
The default timer expiration period is 60 seconds.
Command Mode
Global Configuration mode
2CSNXXX_SWUM204.book Page 550 Monday, January 25, 2016 1:25 PM