Administrator Guide

Layer 2 Switching Commands 570
Command Mode
Link Dependency mode
User Guidelines
The action up command will cause the group members to be up when no
depended-on interfaces are up.
Example
console(config-depend-1)#action up
link-dependency group
Use the link-dependency group command to enter the link-dependency
mode to configure a link-dependency group.
Syntax
link-dependency group GroupId
no link-dependency group GroupId
• GroupId — Link dependency group identifier. (Range: 1–72)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
The preference of a group is to remain in the up state. A group will be in the
up state if any depends-on interface is up and will be in the down state only if
all depends-on interfaces are down.
Example
console(config)#link-dependency group 1
console(config-linkDep-group-1)#
2CSNXXX_SWUM204.book Page 570 Monday, January 25, 2016 1:25 PM