Administrator Guide

Layer 2 Switching Commands 630
no mvr group A.B.C.D [ count ]
• A.B.C.D —Specify a multicast group.
•
count —Specifies the number of multicast groups to configure. Groups are
configured contiguously by incrementing the first group specified.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration
User Guidelines
The following table lists the completion messages.
Example
console(config)#mvr
console(config)#mvr group 239.0.1.0 100
console(config)#mvr vlan 10
mvr mode
Use the mvr mode command in Global Configuration mode to change the
MVR mode type. Use the no form of the command to set the mode type to
the default value.
Syntax
mvr mode {compatible | dynamic}
no mvr mode
• compatible —Do not allow membership joins on source ports.
Message Type Message Description
Successful Completion Message None
Error Completion Message • Not an IP multicast group address
• Illegal IP multicast group address
2CSNXXX_SWUM204.book Page 630 Monday, January 25, 2016 1:25 PM