Administrator Guide

Layer 2 Switching Commands 632
Example
console(config)#interface Gi1/0/1
console(config-if-Gi1/0/1)#switchport access vlan 10
console(config-if-Gi1/0/1)#mvr
console(config-if-Gi1/0/1)#mvr type receiver
console(config-if-Gi1/0/1)#exit
console(config)#mvr mode dynamic
console(config)#mvr querytime 10
mvr vlan
Use the mvr vlan command in Global Configuration mode to set the MVR
multicast VLAN. Use the no form of the command to set the MVR multicast
VLAN to the default value.
Syntax
mvr vlan vlan-id
no mvr vlan
• vlan-id — Specifies the port on which multicast data is expected to be received.
Source ports should belong to this VLAN.
Default Configuration
The default value is 1.
Command Mode
Global Configuration
User Guidelines
The following table lists the completion messages.
Message Type Message Description
Successful Completion Message Defaulting MVR query response time.
Error Completion Message None
2CSNXXX_SWUM204.book Page 632 Monday, January 25, 2016 1:25 PM