Administrator Guide

Layer 2 Switching Commands 638
The following table explains the output parameters.
Examples
console#show mvr members
MVR Group IP Status Members
------------------ --------------- ---------------------
224.1.1.1 INACTIVE Gi1/0/1, Gi1/0/2, Gi1/0/3
console#show mvr members 224.1.1.1
MVR Group IP Status Members
------------------ --------------- ---------------------
224.1.1.1 INACTIVE Gi1/0/1, Gi1/0/2, Gi1/0/3
show mvr interface
Use the show mvr interface command in Privileged Exec mode to display the
MVR enabled interfaces configuration.
Syntax
show mvr interface [ interface-id [members [vlan vlan-id ]]]
• interface-id —Identifies a specific interface.
•
vlan-id —VLAN identifier.
Default Configuration
This command has no default configuration.
Error Completion Message MVR disabled
Parameter Description
MVR Group IP MVR group multicast IP address.
Status The status of the specific MVR group. It can
be active or inactive.
Members The list of ports which participates in the
specific MVR group.
Message Type Message Description
2CSNXXX_SWUM204.book Page 638 Monday, January 25, 2016 1:25 PM