Administrator Guide

Layer 2 Switching Commands 652
Example
The following example configures the system priority to 120.
console(config)#lacp system-priority 120
lacp timeout
Use the lacp timeout command to assign an administrative LACP timeout.
To reset the default administrative LACP timeout, use the no form of this
command.
Syntax
lacp timeout {long | short}
no lacp timeout
• long — Specifies a long timeout value.
•
short — Specifies a short timeout value.
Default Configuration
The default port timeout value is long.
Command Mode
Interface Configuration (Ethernet) mode
Interface Range mode
User Guidelines
The LACP time-out setting indicates a local preference for the rate of
LACPDU transmission and the period of time before invalidating received
LACPDU information. This setting is negotiated with the link partner. Long
time-outs are 90 seconds with a transmission rate of once every 30 seconds.
Short time-outs are 3 seconds with a transmission rate of once every second.
For further information, refer to the LACP_Timeout setting in IEEE Std.
802.1AX-2008.
Example
The following example assigns an administrative LACP timeout for port
Gi1/0/8 to a long timeout value.
2CSNXXX_SWUM204.book Page 652 Monday, January 25, 2016 1:25 PM