Administrator Guide

Layer 2 Switching Commands 704
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures a match condition for the specified MAC
address and bit mask.
console(config-classmap)#match destination-address mac AA:ED:DB:21:11:06
FF:FF:FF:EF:EE:EE
match dstip
Use the match dstip command in Class-Map Configuration mode to add a
match condition based on the destination IP address of a packet.
NOTE: This command is not available on the N1500 Series switches.
Syntax
match dstip ipaddr ipmask
• ipaddr — Specifies a valid IP address.
•
ipmask — Specifies a valid IP address bit mask. Note that even though this
parameter is similar to a standard subnet mask, it does not need to be
contiguous.
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
2CSNXXX_SWUM204.book Page 704 Monday, January 25, 2016 1:25 PM